Mô tả

Wichita Water Cooled Brakes provide high heat dissipation in a cost effective design. The proven air tube actuation allows precise web tension with simple air controls. A simple,cost effective design, with a one piece steel water jacket to eliminate leakage.

Characteristics

Pneumatically applied – spring release
Water cooled for good heat transfer
1, 2, 3 or 4 disc design
Standard or Low Coefficient (LC) friction pads for various torque requirements
Multi-range actuators for optimum torque selection optional on some sizes
For use in dry environment only

Utilisation

End-of-shaft or through shaft mounting

Typical Uses

Continuous slipping and tension control applications
Heavy duty stopping and holding applications
Fast engagement and cyclic applications

Mounting Precautions

Outer ring of brake must be supported by machine frame
Inner hub of brake must be supported by machine shaft
Designed for horizontal shaft axis. Consult Wichita if vertical mounting is required
Maximum water inlet pressure is 4.5 bar

Safety